EDIS Megasquirt Wiring

[ryankalel]

Hello all....

I am getting to MS my B20 and I have a few questions about the wiring. In this diagram pin #7 says that it need to go to the VR sensor and PIP, SAW. Do I need to just splice the wire and run it?
http://www.savetheledges.org/test/AVS/images/tech/edis4.jpg

When I pulled the wiring from the donor car it has some braided looking wires the wrapped around some of these. Do I need to keep those and insulate it or just insulate it?

Thanks

[qwkswede]

Yeah, this is just the shield on those sensors. The outer braid on the wires from all these sensors will just tie together at pin 7. I think pin 7 just goes to ground somewhere in the module anyway. But thats the idea.