MS and Volvo's 60-2 Wheel

[AnthonyH]

Ok, I've had my car running for a week now on the Volvo 60-2 wheel.

As you see, Volvo's 60-2 wheel, the 2 missing teeth are actually 2 teeth, raised. But on my old Missing tooth wheel, the 2 missing teeth were recessed. Anyway, the engine starts fine, runs fine. I'm wondering if I should switch polarity on the sensor wire or if I should re-jumper the MS board to VrIn- Inverted. This is because Volvo's wheel, the teeth are inverted compared to my previous wheel.

I don't have a scope to capture the signal. Grrrr...

Cheers!

[Karl Buchka]

If it works, it works. Why screw with it?

[The Aspirator]

Hey Anthony, check out my recent findings in this thread (you don't have to read the whole thing ;-)). Scroll down to post 12 and you'll see a section for Megatunix, that will allow you to "see" what the VR sensor is doing, same thing as a scope but with a computer. It's pretty awesome actually.

Edit, ha maybe I should post the link, duh:
http://forums.turbobricks.com/showthread.php?p=1575799