960 ignition drivers, bosch %203 i think ...

[kildea]

so anyone have diagrams of these buggers?

i managed to mangle my vb921's and one lost a leg, so i'm just going to use the stock 960 drivers (they are just sitting here anyways :)), wasted spark from my led out on ms1 v3 board, as-if they were vb 921's.


so what voltage do they need to see ... ie should i use resistors in-line as with the vb921's to get it there?
also, any suggestions concerning capacitors at the coils, are these necessary from your experience?


thanks in advance,
j

[v240tic]

Bosch 0 227 100 203
http://www.dubnet.org/imgs/vr6ignition/ignitionmodules.pdf

[kildea]

thank you again!



cheers,
j

[DaButcher]

if you do this, you dont have to think about dwell.. However, I read on ms forums that this is no longer the preffered way of doing it. Now they recommend vb921s (dont know why)

[v240tic]

According to OEM documentation, the ECU controlls the dwell...

[benflynn]

get a 6a

[linuxman51]

get a 6a

perhaps... 3 6a's if we're trying to light off an I6 with wasted spark..