B-dub
08-19-2008, 02:16 AM
Ok so I have the Glen's Idle motor driver in and it's working wonderfully. Are there some Idle settings that I should change now that I'm using the idle valve?
The car hasn't freaked out on me yet since I put it in. I also made sure the grounds were better, and I shielded the trigger wire going to the 139.
That's good news, but the injector driver is still getting really hot. I probed for power and there is 13+ volts going to it while the car is running. If you are looking at the MS with the IC at the top right it is the third leg down on the right that is showing 13+volts. I didn't know if that's normal.
It feels like I'm getting closer...
The car hasn't freaked out on me yet since I put it in. I also made sure the grounds were better, and I shielded the trigger wire going to the 139.
That's good news, but the injector driver is still getting really hot. I probed for power and there is 13+ volts going to it while the car is running. If you are looking at the MS with the IC at the top right it is the third leg down on the right that is showing 13+volts. I didn't know if that's normal.
It feels like I'm getting closer...