Nitrous switching v2.2

[B-dub]

Who's done it and how did you set it up? I have the wiring diagram from the msextra site, I was just hoping for an alternative.
Can I just run a low signal into JS1 pin6 with a diode to switch the tables, and a wire with a diode from JP1 x3 switching a relay that will control the nitrous solonoid?
Thanks as always! I couldn't do this with out you all!

[RvolvoR]

sam was using a dry shot and MS to inject the extra fuel needed. Kenny is/was using MS as basically a window switch

[B-dub]

sam was using a dry shot and MS to inject the extra fuel needed. Kenny is/was using MS as basically a window switch
Using MS as a window switch is what I'm looking for...
Any reason this won't work?
http://i24.photobucket.com/albums/c3/BDUB79/MSnSnitrouswiringdiagram.jpg

[Matt Cramer]

The processor pins can't drive a relay directly; you'll need a relay control circuit at the very least.

[B-dub]

Somthing like just using a 2N2222A, and a 1K like this? Is there a difference between 0volts and ground?
http://i24.photobucket.com/albums/c3/BDUB79/nitrous-circuit3-1.jpg

[linuxman51]

0volts is ground.

[linuxman51]

mine will not be controlled by the ms any more, however I will be doing table switching with it.