View Full Version : General Inputs and outputs what would I ever want to use these for?
06-03-2006, 11:09 PM
So i am finishing up my tec3 install.
I plan on using a general output for fan control and boost solenoid....anything else?
I am unsure what to use the general inputs for?
Traction control?.....not sure.
Does tec3 do table switching?
06-04-2006, 12:00 AM
06-04-2006, 12:11 AM
shift light, nos, fidle, outputs for dataloging
06-04-2006, 11:28 AM
it already does datalogging...
I don't think I will ever run NOS....just too on the edge for me..
Poik, what do you mean by table switching?
06-04-2006, 11:44 AM
launch control. If I get serious and my wife lets me keep the car :x: I'll be hooking that up. holds rpm down to XXXX when the clutch is pressed.
Table switching, as in you can have 2 spark maps and flip a switch to switch between them. This switch could also be in series with a WOT switch and nitrous arm, to retard timing if you run nitrous. Etc.
vBulletin® v3.8.7, Copyright ©2000-2013, vBulletin Solutions, Inc.