stock 16v injectors what are the specs?

[spongemonster]

At the moment I'm running stock 16v injectors in a n/a 16v. I need to find the values for them so I can get megasquirt up and running. I've tried searching already and couldn't find the info. Thanks
James

[spongemonster]

Ha! I lied I found that my injectors are 236cc/min. Now I've gotta figure out what to set for all the other variables.

[The Aspirator]

Set everything else just the same as other people have on their volvos. Maybe even take Kenny's 16vt map and just cut off all the boost part and stretch out all the off-boost bins.

[spongemonster]

Yeah I'm basically flying by the seat of my pants here figuring it out as I go. I've got an applicable map but it was using larger injectors.

[linuxman51]

you can drop the REQ fuel value, easier than trying to calculate one.

[spongemonster]

Hahaha well huh that'll teach me to think too far into things> Right now I'm just pulling theory out of my ass until i get it hooked up and see what values change what. Thanks for helping out a bit of a noob guys.

[The Aspirator]

Just hold your breath, buy everything you need, and dive in face first. No use trying to understand how megasquirtz works and how to tune it before you even have it in your hands, that's just begging for a headache.

[spongemonster]

Hehehe yeah I'm just figuring out where the terminated connector goes. I think it's the box in the driver's side near the steering shaft but I'm figuring things out. (this should be under how to make yourself feel like a total noob again)

[spongemonster]

Well it's not on yet. Instead I decided to snap off my throttle spool bracket again. Somehow the third (lower) bolt backed out and it stressed the first 90 deg. bend and broke in the same spot again. It was Saturday night. Luckily while picking up some new headlight bulbs (took the others back cause one high beam didn't work only to find the connector had pushed back and I'm an idiot) managed to get a line on a guy's home shop and he welded it up (I over paid him cause he saved my ass in a big way).

Anyhow I have everything I need and tonight the car will run for the first time on megasquirt (I'm excited even though yes I took the easy way out and bought prefabbed stuff). One of these days I'll get everything together and show what I've had in the works for years now.
James

[The Aspirator]

What did you do for a wiring harness? Cause as far as I know Kennah doesn't make complete harnesses. Did you just throw terminals on one of his half-harnesses?

Best of luck, here's to no problems when starting it up! :cheers:

[spongemonster]

Nope he actually does make full plug and play stuff for lh2.4.