Wiring V3 board for EDIS?

[RvolvoR]

alright guys, im trying to help one of my friends here in charlotte out with his MGB. He already has Megajolt Lite Junior running on it and we have been trying to make heads and tails of the instructions to convert his V3 board with extra firmware for EDIS. Can anybody help out?

[740ATL]

The instructions on the msns-e sourcepage are pretty good... what specifically does he have questions about?

http://megasquirt.sourceforge.net/extra/edis-hardware.html

[RvolvoR]

The instructions on the msns-e sourcepage are pretty good... what specifically does he have questions about?

http://megasquirt.sourceforge.net/extra/edis-hardware.html

what jumpers on the v3 board do we leave or cut

[740ATL]

I did some searching... the base msns-e page is sparce. If you check their manuals page, it's much more detailed. I don't see any jumpers you need to cut, but there's two you need to add. It looks pretty straightforward.

http://www.msextra.com/manuals/MS_Extra_Ignition_Hardware_Manual.htm#edis

[RvolvoR]

I did some searching... the base msns-e page is sparce. If you check their manuals page, it's much more detailed. I don't see any jumpers you need to cut, but there's two you need to add. It looks pretty straightforward.

http://www.msextra.com/manuals/MS_Extra_Ignition_Hardware_Manual.htm#edis

Well we added the two jumpes, but we still managed to hear some **** go POP

[740ATL]

define pop? :) Can you take a picture of the board/mods?

[RvolvoR]

yeah, i can eventually, I think we spotted an acidental solder bridge