Search results

Originally a b21f bw55 car that I bought from Simon Babbs. I bought the 242 a fews years ago for the rear end that had a 1031 with a turetrack. My white wagon had blown up the rear end, might as well buy the whole car and use the rear end for my wagon. After swapping the rear end back to another...

Originally a b21f bw55 car that I bought from Simon Babbs. I bought the 242 a fews years ago for the rear end that had a 1031 with a turetrack. My white wagon had blown up the rear end, might as well buy the whole car and use the rear end for my wagon. After swapping the rear end back to another...

Bought a 1992 wagon that was converted to a d24 for some season the camshaft was broken in half. I had another good d24 I was going to put in as a replacement. Sold the good d24 and decided to do a V8 5.3 vortec instead. Bought a 2004 tahoe with 4l60e 2wd that was wrecked with 130k miles for...

Building a b230ft with stock internals with a flat flywheel and lh2.4. Going to use a T5 but like a nice clutch setup that's not going to fail and have to remove again. I need the clutch setup before I goto the machine shop so everything can be balanced. I was thinking of running a 240 HD...

I bought an 84 242 DL that is originally from California and made its way in Oregon sometime in early 2000s. The fenders were swapped from a 86+ 240 as well the flathood, grill and headlights. A b23ft was swapped in and converted to Lh2.2 with an M47. Then was sold maybe 2009, I remember the for...

My 242 I bought back in 2008 and my first Volvo I bought. I paid only $350 for the car. The car was left with a half a tank of gas for five years. After switching fuel tanks and pumps and some basic maintenance it was my daily driver through high school. My goal was to do a resteration project...

Have a b23ft 405 head with a b21f intake. 2.2 ezk 330cc injectors.I started noticing the car hss been running rich under a high rev under decel. It not everytime it does this its hit and miss. Air fuel spikes at 8.0 and then leans out. Any ideas?

Building a B23FT build I'm using the stock M rods, Wondering if its Necessary to change out the rods studs and nuts?

I have a 89 240 and the turn singals dont work. I have change the relay with a good working one, and change out the turn singal switch also and still they dont work. The 4 way hazard work fine and I hear the relay turn on. The Two yellow wires dont have any power to the turn singal switch. Only...

I was wondering if anyone had bench flow test a automotive 16 valve head and penta head? I would like to know the difference between the too heads

I have a 93 240 and the ABS light is on, I clean the two magnet sensors in the front brakes. I tried disconnecting the battery, for 10 minutes and that didn't work even after I cleaned the sensors. Is there a fuse underneath the front passenger seat? Any ideas?

What's the wheels color code?

Wondering if a set of thors (17x7.5 offset 49mm) will fit R brakes from a s60R. Or what spacers do you need to clear the calipers.

I want to tap my oil drain in my b21ft. What kind of NPT tap should I use?

Finally have the car almost finished. Here is a short video of it running. :cool: <object width="425" height="344"><param name="movie" value="http://www.youtube.com/v/Qkyz26WDAAo?hl=en&fs=1"></param><param name="allowFullScreen" value="true"></param><param name="allowscriptaccess"...

Does anyone know what the thread is inside of a 240 strut tube?

I need the belt size for the A/C bypass kit.

I have a 83 244 turbo that I did just did a head job. Before I did the head job I was showing signs of a blown head. the coolant was bubbling inside reservoir. I did the headgasket and still showing signs of a blown headgaket. I used a stock size heqdgasket replace everything with the head...

Still have not sold my gb wheels so ill be putting them on my 72 145. Ill be getting them powder coated and would like to see what color I should make them. here is a picture of my145. right now i have 15 inch moon caps