• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

nordmaschine
Reaction score
3

Profile posts Latest activity Postings About

  • Hello there,

    I read that you had disabled your EGTC on b204ft.

    How did you do that? :) I have a b204gt with broken egtc so the car just jump and wont boost anymore..

    Thanks in advance :)
    I already have a separate e fan system. But if i switch the the ECU for a b230ft ECU, and switch the tps i must het the system work right? Or is it not that easy? And offcourse make the turbo with a mbc or something. And i have ordered a wideband o2. I appreciate you're input!
    I dont mind to have codes or something. I just want to be sure what the code does to the ecu. So the false egtc signal dont change the Output of the ECU that much. I ordered a afr meter so i can see, what i am doing. I think i go for the option to remove the tcu. And just wire the load signal to the ezk. But is a lh2.4 b230ft ECU not a straight fit on the connector from the loom inbthe car? Or is the loom different?
    Thanks for your reply it is very useful! I am not conerned about a flashy red light on the Dash or something. I was just curious that i dont Fry mine engine. Because it just had a rebuild at the last owner for 15000 km ago. The drivebelt snapped and all the valves went bend. So i have new valves, new pistons, and new conrods. And i hate the codes on the egtc. I have a great experience in building gr a 242 turbo rally cars and some more cars. And i was just wondering on how easy it is just to lose the tcu and egtc. Because the next step was a free programmable ECU or something if i cant delete the codes. Can i just remove the tcu and use a mbc? And rewire pin 25 to the ezk? Or do i still have fault codes in the ECU? Because i also want no faultcodes in the ECU so i know it have no codes or something and it just run smooth as it should be. Thanks a lot so far!! You really helped me!
    Hello nordmaschine,

    I have seen a topic, where i saw a comment of you that you rewired the egtc on a b204ft/GT. Would you like to tell me something more about it? I own a 760 b204ft with a m90 gearbox. But i have a fault on the egtc. I would really like to know how to remove this sensor. Do you still have faultcodes or something in the ECU?

    With kind regards,

    Bas Knuif
  • Loading…
  • Loading…
  • Loading…
Back
Top