Complete MS install
 

I was running Kennys plug and play on my 90 240. After a engine fire and having under hood wiring damage. I decided to pull the factory harness out and just run whats needed for MS2. There was a good simple guide on Turbobricks that I believe was done by Linuxman. Well, Ive searched and searched cant seem to find it now. I know I can just use the MS diagram but would be nice to find that guide and have it posted here for others to use. So asking does anybody have it saved or knows how to find it. Thanks a million

Hey, after 3 hours I found it. Here is a link. How to wire in your megasquirt
http://forums.turbobricks.com/showthread.php?t=26720

that's really old, but... mostly still the same. You'll be using the crank sensor (3 wires) instead of a hall-effect distributor. for the spark output, just connect ign1 straight to the trigger pin on the 129

Thanks will do.

Yoshifab has a great manual too.