• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

240 accessory bushings - what to use ?

I was going to suggest the Yoshi aluminum ones. I had a blue IPD fail two months ago. If you had a Yoshi aluminum fail, then I don't know what else there is. Maybe have someone make some out of bronze or brass on a lathe?
 
The blue Uro ones that FCP sold were great until they weren't.
Anyone try the SuperPro urethane ones?
 
alternator
F03ZrXEh.jpg


QwXGKr7l.jpg
 
I put Meyle rubber bushings on my car about 2 years/30k miles ago. The PS and AC bushings still look fine, but the alternator bushings were starting to deform so I replaced them with Volvo bushings. The Volvo and Meyle rubber look the same to me.
 
bracket is/was fine I put used oe bushings and seems to be fine ...




I think I just answered my question

Maybe yoshi and ipd poly wear out because they allow rotation while stock "sticks" in housing

I just have a special interest in those bushings (especially the alternator).

This summer, I was working butt**** nowhere (60 miles down a logging road around Horsefly,BC) and the alternator bushings (probably the original ones) deformed and broke the adjusment bracket. I had to drive about 150 miles like this, worked surprisingly good.

l93iZzcl.jpg
 
Back
Top