• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

Awww (15g flat flange problem)

hidalgo.ceo

New member
Joined
Jun 16, 2010
Location
Richmond, Va
I just muffed up the compressor seating flange on a 15g flat flange exhuast housing can I machine it down or I am just screwed. To let inquiring minds know how what happened Ilet the drill rub on it while trying to drill out two broken studs. NOOOOOOOOOOB move I KNOW! Please Turbobricks HELLLLLLP!
 
I was hoping that I could mill the lip down flat because the mark did not go deep enough to cut into the pocket that the turbo sits in. Is this an option I was hoping it would be longshot but doable .
 
Back
Top