• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

MikeJr's 242 Project

scottyd said:
Looks good.
Any pics/details of the brake booster that was used?
Click to expand...

It's out of an S40, but I'm not sure what year, or what all was done to make it work. The bad part about it that the reservoir is to tall and blocks the strut to firewall brace.
149930869.jpg

149930872.jpg

149930876.jpg


Current engine shot. Basic B23F
149930879.jpg
 
Last edited:
gawd i want you to paint my 242.... but i dont haz the $$$$$s


this looks amazing, keep us update so we can see what a paint job looks like
 
towerymt said:
Both locations were used, as seen here:
http://www.pbase.com/towerymt/image/9401976.jpg

I prefer the wider spacing, that little corner is quite strong. But if you cut out all the support structure of the hood, it'll flop at the center as we saw on another 240 at the last lemons race (they added a third pin in the center front).

mine ;-)
http://www.pbase.com/towerymt/image/135519188.jpg
Click to expand...

You had me worried for a second. :-P

That place that I did put them on the core support is a very strong part of the support.
 
You must log in or register to reply here.
Back
Top