ALR11606
New member
- Joined
- May 24, 2012
- Location
- Louisville Ky
As long as that setup ends up under the hood eventually. Won't the gt45 alone be a bit...big for the little 2.3 though?
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
As long as that setup ends up under the hood eventually. Won't the gt45 alone be a bit...big for the little 2.3 though?
Nice, Make sure to post Dyno vids/Graphs!
I would be tempted to weld a 16v flange on this. Haha.
So you decided to scrap it when most of the fab work was done, just to get a 75 x 50 pixel badge on an internet forum? FINISH IT!!!!!
That sucks mate. ****in' RHD, I want this
I got a LHD 1983 242 B23/M46 that I can bolt to it to make you one big package deal!!! The 242 doesn't have butt cheeks and all of the side trim and rocker trim holes have been welded and smoothed too.