View Single Post
Old 12-06-2017, 12:14 PM   #169
soclosenotnear
Board Member
 
Join Date: Oct 2011
Location: summerville, south carolina
Default

I'm trying to order parts for my 3" amm/heat shield/green giant injectors install.

I'm working with a do88 3" inlet hose and a bsr heat shield that I'll have to cut to accept a 3" amm.

I feel like I've read the factory 90 bend between the filter and amm is needed to create some sort of air swirl. Is their any truth to that or did I make that up? I've had an air filter stuck on the end of my amm for a couple thousand miles now but am trying to make a permanent solution. Can anyone comment on if I should try and work that 90 bend into my air box or just plop the filter right on the end of the amm?
soclosenotnear is offline   Reply With Quote