MadDog_945
Våga Vägra 8V
- Joined
- Apr 25, 2006
- Location
- Lower Saxony
advanced womanly skills
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
While most people at work are on vacation I had some freetime to design this...
I already printed it 1:1 (only half of it - it's symmetrical) and it's a good fit.
Im going to get a 1650x550mm sheet of plywood for my first try. Thinking about fiberglass.
It's a 3D scan you can find online with a bit of searching. I scaled it and confirmed it was scaled correctly by measuring varius dimensions. It's rough but workable.
I can upload the stuff tomorrow and send it via PM.
That would be awesome. Thanks!
Yeah.. because now it looks gooey and moldy
Still needs more camber and spacers ! Nice Car!
Should be okay because of the AMM on the cold side, yeah?
Very clean engine bay, props to that!