6thousandths
New member
- Joined
- Nov 29, 2017
- Location
- Tempe, AZ
I have started work on a new build, this is my first volvo, other than our 2012 C30 (which is a stock R-design polestar tune). I plan to build this for drifting and other weekend activities.
I can take more pictures if anybody would want to see something specific
This may be an unconventional brick but I decided to share it anyway.
The day I picked it up, blown engine, massive knocking due to oil starvaion:
Here is the front end stripped, with a complete s14 240sx front subframe and steering rack modified to fit. Also is a brake master/booster, and clutch master from a Z32 300zx. This setup fits s14 coilovers really well. I think the caster will be a degree or two less but should function well regaurdless.
Engine and transmission installed, 1jzgte VVTI with R154 from a JDM toyota chaser. This engine was previously in my infiniti M30 track car
Fitting the rear subframe now, going to be a challenge to make it fit right and drive well, I will be using a C-channel installed across the frame rails. I am working on this now
This is how it sits right now. I am getting a tube bender and will be building a front end this weekend hopefully.
I can take more pictures if anybody would want to see something specific
This may be an unconventional brick but I decided to share it anyway.
The day I picked it up, blown engine, massive knocking due to oil starvaion:
Here is the front end stripped, with a complete s14 240sx front subframe and steering rack modified to fit. Also is a brake master/booster, and clutch master from a Z32 300zx. This setup fits s14 coilovers really well. I think the caster will be a degree or two less but should function well regaurdless.
Engine and transmission installed, 1jzgte VVTI with R154 from a JDM toyota chaser. This engine was previously in my infiniti M30 track car
Fitting the rear subframe now, going to be a challenge to make it fit right and drive well, I will be using a C-channel installed across the frame rails. I am working on this now
This is how it sits right now. I am getting a tube bender and will be building a front end this weekend hopefully.