View Single Post
Old 11-29-2018, 06:51 PM   #7
smeha
Tranny Whisperer
 
smeha's Avatar
 
Join Date: Mar 2017
Location: California
Default

Quote:
Originally Posted by intothelabyrinth View Post
One side goes to the test connector (red or pink wire) and the other side goes to 12v... Basically the ecu grounds the test connection when it senses a rich condition, which lights up the light, then un-grounds it when its lean. It should cycle rich for a sec, then lean, back and forth.
Yeah, I misspoke. I was already looking at the diagram of led test light, but why you didn't use resistor in your picture? Did this setup works better or same?
__________________
1988 Volvo 245DL (Engine: B230F) (Transmission: AW70) (Fuel Injection: LH 2.2) (Brakes: Non-ABS) (Paint code: 189-2) (Dank memes)
1997 Jeep Cherokee Sport (XJ) (Engine: 4.0L - I6) (2WD)
My Feedback Thread
Quote:
I've been molested by a guy who happened to own 7 and 9 series
<--- Just a dumpster on fire
smeha is offline   Reply With Quote