- Joined
- Oct 10, 2003
- Location
- Acworth, GA 30102
Updates?
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
Isn't it in your garage?
Would you mind giving me specs on that steering shaft? I'd like to get rid of my tapered one and spare some much needed room!
Yeah sure, I'll get you some part numbers and venders too.
Yeah sure, I'll get you some part numbers and venders too.
Really just wondering spline count amd diameter, my stock ones to wide uptop.
Awsome thanks. The joint you linked, is that exactly what you used? I don't see set screws on them and don't want to go the weld on route. Did you grind notches in the steering shaft for the oe upper joint?
updates?
What rear end in it? 1031? 8.8?