FROSTED_BVTTS
Member
- Joined
- May 21, 2020
- Location
- Eagle Rock, MO
Working on MSing my 245 and I've run into an issue. Ignition timing is advancing as RPMs increase with the advance set to fixed mode. I'm using MS2 V3.0, LH2.2 distributor hall sensor for crank signal, Bosch 124 ignition module, and the stock coil. I'm using the resistor method for spark output through D14 as described in the hardware manual here. I've tried setting spark mode to basic trigger and trigger return and input capture as rising edge and falling edge, no difference. Spark Output is set to going high, I get no spark when set to going low. Crank signal seems good, don't think I've had any sync errors.
Anybody run into something like this before? Hoping I'm just an idiot and did something wrong, cause I'm pretty well stumped.
Anybody run into something like this before? Hoping I'm just an idiot and did something wrong, cause I'm pretty well stumped.