Thread: 1+1=245
View Single Post
Old 10-15-2013, 12:17 AM   #74
Jack
junkman
 
Jack's Avatar
 
Join Date: Jul 2011
Location: The Ass Cheek Of History
Default

Quote:
Originally Posted by 245Mike View Post
How did you do this?

ran a T fitting from the mani (has to be behind the throttle body)
connected it to old pcv plastic tube that goes through the firewall
inside I ran a silicone vacuum tube to the gauge.

here are instructions just in case
http://www.240.se/install/3-38-11.pdf

and here is a picture pretty in pink



Quote:
Originally Posted by 122power View Post
On your brake fluid check that sensor down on the proportion valve. Mine was loose for some reason and the fluid all leaked out.
wife trying to dispose of you and collect the insurance

Quote:
Originally Posted by hiperfauto View Post
The valve with the sensor is a splitter/brake failure warning valve, not the proportioning valve. Brake fluid should not leak out of the sensor switch. If it does, the valve is bad and needs to be replaced.
no trouble from this..................................yet
__________________
85 245 | 82 242| 75 245| 69 145 |66 122



Quote:
Originally Posted by BritishBrick
Donít bother, I would literally rather throw them away than give you the pleasure. I will never sell to you.
Jack is offline   Reply With Quote