View Single Post
Old 01-05-2017, 09:10 PM   #161
lookforjoe
Board Member
 
lookforjoe's Avatar
 
Join Date: May 2008
Location: Rockland County, NY
Default

Installed the harness, Power stage & coil pack today. Removed the distributor, coil & standard terminal wire set.

Didn't start, so I checked the continuity for all the power connections. Every looked good. I had removed the ground for the stock power stage (which I forgot included the ECU ground), so I reattached that, and it tried to fire. Didn't sound right at all, so I reversed wires for 1-4 with 2-3, and it fired right up. I had wired IB1 to output 1 & IB2 to output 2 on the daughter card, OC1 to coil pin 3, and OC2 to coil pin 1



- based on this diagram



So, it seems the coil connections are inaccurate - I definitely have OC1 going to coil pin 3 & OC2 going to coil pin 1.

Coil pack & isolater board location



Power stage & heat sink location



Wires in place, distributor removed

__________________

My XR July2013 - 446AWHP @ 8K rpm

Last edited by lookforjoe; 06-05-2018 at 10:13 PM..
lookforjoe is offline   Reply With Quote