View Single Post
Old 06-09-2018, 03:32 PM   #23
Mbeas96
Board Member
 
Mbeas96's Avatar
 
Join Date: Aug 2017
Location: Charleston
Default

The ipd strut brace and damper came in yesterday, along with my valve cover and cam seals, plus the distributor block off plate and plug for the head mounted dist. Its just like christmas morning when I was a kid!

The strut brace was smushed against my throttle spool, where my cruise control cable went. A couple washers from the hardware store and it seems to clear just fine. A little revving in park to try and rock the engine and I think it'll be okay.







The damper, I'm not so sure yet. Its obvious it attached at this point on the brace, but where to attach the other side? Ill have to source a stud with a ball on the end as the damper is just a shock with a socket at the end for the ball to snap into.

__________________
Quote:
Originally Posted by Mr.Bill View Post
You are not a man unless you've thrown up at a turbobricks meet.

My build thread: http://forums.turbobricks.com/showthread.php?t=340910
Mbeas96 is offline   Reply With Quote