Turbobricks Forums - View Single Post - 740 M46 new clutch and pressure plate, how bad is this?

AdmiralSenn · 01-08-2014, 08:29 PM

I think I might stick with the degreaser since I already have two cans. Right now it does hold enough to drive around, it just doesn't hold any power.

I'm going to call FCP and find out how quickly I can get a new disc. I think I'm going to buy a flywheel and have it resurfaced too, just because.

Do you guys think I need to replace the pressure plate? I did the full kit (clutch disk, pressure plate, pilot and throwout bearings) a month ago, but I don't know if this glazing/slipping problem would affect the PP enough to warrant replacing it again.

01-08-2014, 08:29 PM	#5
AdmiralSenn Board Member Join Date: Jan 2007 Location: Vero Beach	I think I might stick with the degreaser since I already have two cans. Right now it does hold enough to drive around, it just doesn't hold any power. I'm going to call FCP and find out how quickly I can get a new disc. I think I'm going to buy a flywheel and have it resurfaced too, just because. Do you guys think I need to replace the pressure plate? I did the full kit (clutch disk, pressure plate, pilot and throwout bearings) a month ago, but I don't know if this glazing/slipping problem would affect the PP enough to warrant replacing it again.