View Single Post
Old 06-13-2014, 08:51 AM   #1
AdmiralSenn
Board Member
 
Join Date: Jan 2007
Location: Vero Beach
Default Driveshaft spacer fabrication questions

Hey all. I'm working out the last few bits of my M90 swap in my 740. I have been unable to find an M90 prop shaft or a shop who can modify an M46/7 prop shaft without shipping it to California or waiting longer than a month. This area SUCKS for car people.

I found this page: http://www.volvoturbo.net/Garagebilder%2023.html which tells me that my next idea of a spacer is at least possible.

I'm going to draw this up and take it to the local fabricator but is there any particular type of steel I should tell him to use? Would regular mild steel hold up or should I use something more exotic? This setup will stop getting upgraded at around 300hp.

Thanks!
AdmiralSenn is offline   Reply With Quote