Gene_GaTech
Round Fender Spender?
- Joined
- Apr 22, 2005
- Location
- Bay Area, California
Want to go from 5x130 to 5x108 any rough idea of how much that would cost?
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
It depends if there's enough meat between the lug holes to drill a second pattern. It might be cheap. If there are pockets between the holes, fill & drill is going to cost a lot more than just drilling.
Use adapters. If you can't, find different wheels. Or pull the fenders. What's the story on the wheels? (what are they, how wide, what offset)
haha, you have no idea.....since no one is actually thinking about running these.
haha, you have no idea.....
You could run thin adapters with those.
anyone make a 5x130 adapter set?
aside from all the dreaming here, i just want to bolt the little ****ers on and be done with it. I'm getting to the point in my life where modifying my dd to the edge of insanity (side exhaust and no mufflers) is getting a bit too much. If someone will come over and do all that stuff for me, i'll pay, but hell i don't want to **** with it.To summariez what bondo said: Redrill hubs for 5 x 130, use porsche brakes
i wish i could get themThose are rad, they're like Barry Bond's custom made Geminis.