View Single Post
Old 03-18-2012, 06:37 PM   #11
M.H. Yount
Board Member
 
M.H. Yount's Avatar
 
Join Date: Nov 2008
Location: Charlotte, NC
Default

Bulkhead fittings installed and the pump test fit. Thought I could open up the plastic clamp enough to fit the DW pump - but was concerned it was too snug and might suffer a stress related failure over time. So ended up making a small 'slit' in the plastic clamp and putting a stainless clamp around it all. Looks like it's going to work fine.





__________________
'82 242 6.2L; '17 Mazda3; '16 CrossTrek

Last edited by M.H. Yount; 02-26-2014 at 08:29 PM..
M.H. Yount is offline   Reply With Quote