2turbotoys
Salaminizer
- Joined
- Nov 13, 2007
- Location
- Reading pa
Yup, came from Oregon. I even know the PO's name, emailed him but guess he doesn't want to talk
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
Are you going to refinish that gauge cluster? The surface finish of most 3d printed things is atrocious.
Depending on the printed material, there are a few chemicals you can use to smooth the build lines (ABS-> acetone, PLA->Tetrahydrofuran). Then it's just some high build or textured paint.
That looks nice! I don't know how to finish it yet, and it was very expensive so I don't want to mess it up. Open to ideas of course. Culberra, not sure what that means, or how to go about it. I have acetone tho haha
Bump for a couple goodies, R Sport repop gauge cluster with adapter for early dash and Stack Pro oil temp, pressure, and coolant temp gauges.
Also got an Autometer boost gauge, and AEM wideband, but the wideband is currently installed in my brother Harley. Who reads plugs anymore haha, use a wideband
Got my 317 heads also. The best part is I can keep my 799 heads, and have a higher compression ratio until it's turbo time. Been going to my friends shop and working on whatever is there to clear the path for my car. This included head studs on a Ford Triton V10 that sucked, and run far away from those turds. Next one should be fun though, Buick Grand National needs some love.
Seriously considering that the '78 242 should be the project car...