MadDog_945
Våga Vägra 8V
- Joined
- Apr 25, 2006
- Location
- Lower Saxony
Hi,
i searched the board and just found irritating and inconsistent stuff around..
so this time serious and with pic and maybe later with add in the FAQ?
So.. heres a nice pic of my 93* FT Block.. i think(hope) the threads dont differ between the years?
Threads used for:
1: Used for waterbased oilheatsink / plugged when using ext., air-oilcooler
2: Banjo for turbo-oilfeed
3: Oil warningcontact / alt. oilpressure
4: additional bore to main waterchannel (dunno what this is used for)
5: Oil Filter Adapter to mount without mounting Arm
6: additional bore to main oilchannel (used @ i.e. camerons Motor for oilfeed)
Thread sizes
now its your turn.. unfortunately i dont have any threadmeasurementtools except for metrical outer threads but not for inner NPTs and stuff...
1: 3/8 NPT ??
2: M14x1,5
3: M14,1,5
4: same as 1?
5: 3/4" 16tpi
6: 1/4" NPT
7: Oil drain / Pan t.b.c.
8: Oil Gallery Bellhousing t.b.c.
9: Oil Gallery Business end t.b.c.
THX ! I hope this would be, when finished, helpful in the FAQ?
i searched the board and just found irritating and inconsistent stuff around..
so this time serious and with pic and maybe later with add in the FAQ?
So.. heres a nice pic of my 93* FT Block.. i think(hope) the threads dont differ between the years?
Threads used for:
1: Used for waterbased oilheatsink / plugged when using ext., air-oilcooler
2: Banjo for turbo-oilfeed
3: Oil warningcontact / alt. oilpressure
4: additional bore to main waterchannel (dunno what this is used for)
5: Oil Filter Adapter to mount without mounting Arm
6: additional bore to main oilchannel (used @ i.e. camerons Motor for oilfeed)
Thread sizes
now its your turn.. unfortunately i dont have any threadmeasurementtools except for metrical outer threads but not for inner NPTs and stuff...
1: 3/8 NPT ??
2: M14x1,5
3: M14,1,5
4: same as 1?
5: 3/4" 16tpi
6: 1/4" NPT
7: Oil drain / Pan t.b.c.
8: Oil Gallery Bellhousing t.b.c.
9: Oil Gallery Business end t.b.c.
THX ! I hope this would be, when finished, helpful in the FAQ?
Last edited: