• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

cleaning pcv on b230ft?

I would order the IPD relocation kit. It's such a pain in the ass to get to the stock setup. It's only like $15 and they give you a new flame trap and all the hoses and everything. I took off the intake manifold to get at it, because I was doing the coolant temp sensor under intake #3 and cleaning the leaking PCV box seal. If you can reach under there and pull the old one off, it's easy to put the IPD kit on. Actually, I had to use a little silicone lube to slide the top hose over the trap housing... that thing is really tight!
 
is there a valve?
or just the box?

I cleaned from box the lil fitting with vac line and hose out...
I didnt clean box itself due to jiggle test passing! lol
do people add catch cans to these cars? the recirc to intake?
I have nissan turbo motors and we all run catch cans then back works great.
 
Oh yeah, I didn't use carb cleaner because it might ruin the plastic. I used degreaser, let it sit, do it twice or more, use a round poker brush thing, then maybe MAF or electronics cleaner that is plastic safe. Get a new seal too.
 
Back
Top