gross polluter
They see me trollin'
- Joined
- Dec 10, 2008
- Location
- DM12
wait, am i missing something here?
Yes. Hall effect gear tooth sensors have existed for many years.
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
wait, am i missing something here?
Got one of these adapters from Mueller for Walters car, hooked it up and fired right up. The signal is SOOO much better it's insane. Car starts better then it did on LH now.
Can anyone verify if the Kia sensor is a plug and play or will I have to cut the wires and splice them in a different location?
No GD&T? Shame on you...
And the gt101 works with the lh-2.4 flywheel? I have 2 gt101
And has anyone tried it with a Vems ecu?
Also, anyone have a link to one of those kia vr sensors on ebay or similar?
1st page of the thread, there is a link for that sensor.
Kurt
Has anyone had to sand down the adapter a bit to improve the sensor to tooth gap when using the diy hall sensor?