My 36th car is my 1st volvo. I need to replace the intake manifold gasket. It is missing badly at idle. I have located the leak. Can I remove the maifold and leave everything attatched to it in place. Also, what are the torque specs? 93 940 non turbo. Plan to cure the non turbo problem soon. Thanks.
-
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software hereThank you for being a part of our community!
940 Intake manifold question
- Thread starter hucos2k
- Start date
scotti
Master Lurker
- Joined
- Apr 17, 2006
- Location
- west chester pa
A few things need to come off but yes you can just unbolt and slide it off.
Only a few things have to come off. What i would do for only and intake gasket on a volvo is take the nuts off the studs that hold the intake on. Then wiggle intake manifold. See what is keeping it from coming back just enough to get the manifold off the studs. Get bungee cords out and use them to lightly hold stuff out of the way. Clean surface best you can. Use mirror to check surfaces you can't see EZ. Then put some Vaseline lightly on the gasket so it will stick in place. Put back together.