View Single Post
Old 03-04-2005, 05:48 PM   #5
Eakin
Board Member
 
Eakin's Avatar
 
Join Date: Nov 2004
Location: Toronto, ON
Thumbs up

I did this last night on my 740. I can't find Seafoam in Calgary, and from what I've gathered, no one else can either. I opted for the GM 'Cleener' or something like that. The instructions were for a carb engine, so I'm not sure if it's 100% safe with my O2 sensor. It did work quite well though. Gave my street a little smoke show. I ended up pulling off the vacum line that feeds the turbo gauge. There was a little connection just before it went in to the firewall. It was the perfect length and then I just added a bendy straw on to the end of it and stuck it in to the glass of water. I followed this up with an oil change after running it through the gears for an hour or so.

Thanks for the great write up.

Last edited by Eakin; 03-04-2005 at 05:54 PM..
Eakin is offline   Reply With Quote