View Single Post
Old 11-26-2020, 10:28 PM   #265
Making Volvo Parts Fit
lookforjoe's Avatar
Join Date: May 2008
Location: Rockland County, NY

I got the shifter & cables back in, the slave cylinder reinstalled, reattached the starter cables, etc., the water pipes back in, made a new plenum gasket, and installed the plenum

Putting the TB, inlet, Header & exhaust back on

Switched to a different ECU fan PWM controller - less features but comes with directions for DIP settings

Going to add EMPI 12" limiter straps to make servicing the axles without stressing the CV's as soon as the strut is removed - going to go from the (bracket previously used for rear swaybar endlink) control arm to the triangle reinforcement forward of the rear crossmember.


My XR July2013 - 446AWHP @ 8K rpm Feedback Thread
lookforjoe is offline   Reply With Quote