i bought a holset H2E on ebay from ohio truck parts turbo cost me 230 shipped and 80 to rebuild it, not a popular model i guess, the rebuild was from D.W. Deisel, i've had it on my S10 for 3 years with no issues, runs good spools good, makes 467hp at the wheels at 8psi, not any issues except the one time i didn't check the oil pressure to the bearings and pushed some oil by. I would strongly recomend them, if you had a stock engine then chinese would be ok, but if you have money in it there isn't any sense in skimping out on the turbo and wrecking something down the line, it could happen, the turbo i have on my volvo is a .63 hotside garret off a volvo with h trim Turbonetics compressor that i bought from one of the guys on here, it works the balls, doesn't spool till around 2800 which is fine with me, no point in stressing an engine that spins to 7k with no issues, spend the money on a holset hx35 with 9cm or 12cm housing, rebuild it for 40 bucks and call it a day, DONT BUY EBAY REBUILDS! did that on my 13c and it lasted all of 2 weeks and about 500 miles then it was back to pushing oil out the exhaust, bad! 2 quarts in less than 300 miles, should have known when it read "No cheap china part in kit"