So, I've had
this Aeromotive FPR on my 142 since I did the engine swap. It's about 6 months old, I'd say.
It never help line pressure after the pumps primed, and the needle on the gauge always fluctuated up to 7-8 psi. I was getting my TLAO chips dialed in with my light blue (390cc?) injectors, but I couldn't escape a nasty lean condition under boost toward 5k rpm. Increased fuel pressure to 58 psi, and the FPR would BARELY get there. It should be capable of 30-70psi base pressure, so I took it apart to see what was up.
Sure enough, the hole that the ball valve should seal against was worn unevenly. They apparently just drill a hole, after the base is already anodized, and don't put a radius or chamfer on it. I used a counter sink bit and milled a chamfer on the seat by hand, carefully.