View Single Post
Old 01-12-2017, 10:33 AM   #307
lookforjoe
Board Member
 
lookforjoe's Avatar
 
Join Date: May 2008
Location: Rockland County, NY
Default

Switched to Bosch powerstage.






Quote:
Originally Posted by malloy1 View Post

This should be the setup using these two parts:

Out From EZK: -> Into 203:____ Out From 203: -> Into 407:
1-4 output -------> Pin 2 _________ Pin 1 -------> Pin 3
2-3 output -------> Pin 7 _________ Pin 6 -------> Pin 1

Paul
This doesn't jive with the BTI indicated layout for connections between PS and coil - I wired mine following your layout & had to reverse the coil wires for it to run. It would seem I/O pins 2&1 are for 2,3 cyl, and 7&6 are for 1,4 cyl




Edit: Nevermind, the inputs from the board to the powerstage are reversed between the two schematics - that would account for it. My mistake was using your schematic as the wiring reference
__________________

My XR July2013 - 446AWHP @ 8K rpm

Last edited by lookforjoe; 01-12-2017 at 10:39 AM..
lookforjoe is offline   Reply With Quote