ok. Mounted the module, wired it up, even ohmed everything out to make sure I had it all correct. fired it briefly on stock, all good. put relay coil in place of the ignition coil, and put plug wires on coilpack. took forever cranking to get it to start, and when it did, it wouldnt stay running, and was really rough. swapped wires at the coil... backfires... back to the original way. double and triple checked... still runs like ****, if I get it to stay running, i have to hold the throttle open, which is a task of itself... barely touching the throttle and it tries to die... checked spark at the coil itself... very weak and short spark... took voltmeter and checked to make sure when I was able to get it running that I had battery voltage at the coil.. checked my ground while it was running between the block and the module... 0.018 volts...
I checked the inputs, factory, 1-3 and 2-4 for voltage while running... I know they are pulsed, but wanted to see the average. factory was between 0.7 and 0.8, both the wasted spark inputs were between 0.3 and 0.5... Pulled the EZK and made sure I was wired in at the board properly, all was good there as well...
Any suggestions? this is with the 203 module, brand new, and the bosch 407 coil, also brand new...
Thanks