View Single Post
Old 09-01-2020, 07:18 PM   #245
Making Volvo Parts Fit
lookforjoe's Avatar
Join Date: May 2008
Location: Rockland County, NY

Got a good amount of work done on the front today. Fill, sand, repeat multiple times

U-Pol gold for the skim coats - much finer than 3M Bondo

Also checking the marker/directional apertures. They needed several add/substract stages to get a better outline

then after that, some U-Pol inside the headlamp opening surfaces

then some filler primer to check overall lay of the land

found I needed to build up the left tuck under the marker - it sat back too far

Spoiler overlap - I need to build up the seams on the body side of the outlying junctions - I have to even out the gap along the rivet area


My XR July2013 - 446AWHP @ 8K rpm Feedback Thread
lookforjoe is offline   Reply With Quote