View Single Post
Old 12-04-2016, 03:19 PM   #80
Broke4speed
Board Member
 
Broke4speed's Avatar
 
Join Date: Oct 2009
Location: Marionville, Ontario, Canada
Default

Cleaned and installed the engine-side engine mount brackets. I wasn't planning on getting new mounts, buuuuuuuuuuuuut, I think it's a necessary item. I may splurge on a tranny mount too, but it's still in good shape.

I also hooked up the fuel feed line, using the original carbed line...which is nylon, just like the efi cars. The chassis harness/fusebox also had the fuel pump wiring already in it, so I only need to run 12v to the harness at the wire going to the in-tank pump, and it runs fine. I tested it...and dumped a bunch of gas on the garage floor, lol. Still pretty happy though .
__________________
1984 244/ AQ140A / M46
Broke4speed is offline   Reply With Quote