View Single Post
Old 08-31-2020, 09:11 AM   #190
sksmith
Board Member
 
sksmith's Avatar
 
Join Date: Nov 2007
Location: Back in St. Louis, MO
Default

Quote:
Originally Posted by TurboDutch View Post
Can you post settings of your welder here? What are you using? 0,6 or 0,8 wire with co2/argon mix?
I think you are being a bit afraid of making holes :P
I'm using a Lincoln Handy MIG, 120V with co2/argon gas. Wire size is .023. Ran out so I ordered a new spool of ESAB "Easy Grind" .023 wire. Not sure, but I believe that would be 0.6.
Settings on the welder are a dial for wire speed, set at approx. 5.25, and two switches for heat range. The switches are set to "High" & "1", per the recommendations on the welder.
And you are correct about being afraid of making holes!!!
sksmith is offline   Reply With Quote