• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

Volvo 242 2,5 16v widebody build

You have more picture's of when you widened it, did you cut and fill like the first picture? Or did you pound it out and then just fill in the under side of the wheel well like in the picture you showed. These cars were the stance I always wanted for my GT, but yours is really one up-ing them.

177345-2080714.jpg


Bilenferdig2.jpg
 
if you look at the weld just behind the door, you can see that i have filled in about 1-2 cm of steel there. and on the topp of the panel, i have filled inn up to 3 ish cm.
DSC00728.jpg


2-4.jpg


3351.jpg


3354.jpg
 
AN 10 - 3/4" Unf, this is where im going to run the oil into the block.

307.jpg


Did some more work on my front bumper today, painted it black to make it easyer to spot where i need to do some more sanding etc..

This is only going to be a plug, a glassfiber mold will be made. and then ill cast a carbon bumper in the mold!

306.jpg


305.jpg
 
Do your plans include any block filler and maybe a main girdle with a oilpan/block tiein?
 
Back
Top