• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

940et Swap Tuning Issues

cooper2jay

New member
Joined
Sep 16, 2018
Location
Oregon
940et Swap Microsquirt Tuning Issues

Hello all,
This is my first post on this website and I was wondering if I could suck some knowledge out of your minds.
So about two months ago, I undertook the project of putting a B230 out of a 940et into my 1987 244. I purchased the Microsquirt and made my own wiring harness out of the blank one that came with my ECU. I did some digging and I found kind of a base map tune to modify just to get my car started before I could do some street tuning.

Tuner studio is reading an RPM value and showing pulse width, but the car just cranks, no sputtering, no farts, nada. I know I'm getting spark, I tested that, and I can smell the fuel in my up pipe. I think it might be an issue with my DWELL values.

I'm using the Bosch 124 ignition Module with the Hall sensor and the Dizzy.

Any incite y'all could give me would be greatly appreciated this has been giving me a headache for the longest time. This whole tuning thing is foreign to me.

https://drive.google.com/open?id=1f84JERD9qksGPFCBKzKp3J1aGBZg-Ewb
 
Last edited:
Back
Top