Mueller
Active member
- Joined
- Oct 12, 2004
- Location
- Antioch, CA
This is for the 255 Baby/Guitar Hauler
Doug sent me a chunk of aluminum that needed some work:
Center hole too small for the bearing retainer.........
No tapped holes for the Ford T5 transmission to bolt to the adapter.......
A large square with no outer profile like I made it, basicly a 15"x15x1" plate....
It did have the step machined into it for the bell housing which was nice.
If I have time I might make another one to use for bartering or trade if Doug thinks .75 thick plate would work and if he is okay with me doing so since it is his design more or less (?)(my outside profile and I fixed the DXF sent to me since it had a few bad dimensions)
I believe Roger-Dee will have these plates to officially sell thru his website in the future. I have no desire to go into production, I don't mind making a few here and there but I don't see that happening if Roger starts to sell them.
Doug sent me a chunk of aluminum that needed some work:
Center hole too small for the bearing retainer.........
No tapped holes for the Ford T5 transmission to bolt to the adapter.......
A large square with no outer profile like I made it, basicly a 15"x15x1" plate....
It did have the step machined into it for the bell housing which was nice.
If I have time I might make another one to use for bartering or trade if Doug thinks .75 thick plate would work and if he is okay with me doing so since it is his design more or less (?)(my outside profile and I fixed the DXF sent to me since it had a few bad dimensions)
I believe Roger-Dee will have these plates to officially sell thru his website in the future. I have no desire to go into production, I don't mind making a few here and there but I don't see that happening if Roger starts to sell them.