• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

Serpentine Belt in 240

I know it's a bit out of the T-brickers budget at a whopping $250 for the WP/Alt/PS, but this already exists....
https://shop.klracing.se/sv/artikla...tor-21/drivrem-2-2-2-2-2-2-2-2-2-2/index.html

It's on sale if you want it in blue: https://shop.klracing.se/sv/artiklar/_b230-multiremhjuls-sats.html

The crank pulley is around $130, and they even make them with a bolt pattern for a tone ring.

Easyoff oven cleaner will remove the blue :)

I'd want hard anodized or steel if a daily driver, of course not as critical as a timing belt as long as the belts don't slip.
 
I'd be very interested in a kit. I just don't want to engineer it - so could someone get on this. Sure there are pulleys, but only for alternator and not for the PS pump and no tensioner. It would be great to clean up this part of the engine bay.
 
Dirty Jack sent me some parts....I mean Jack sent me some dirty parts.
 

Attachments

  • 5112017111954.jpg
    5112017111954.jpg
    193.1 KB · Views: 348
Holy back from the dead I know. That said, did anyone else ever make one of these?

Not here, but started investigating and pinned down part numbers for a 2 belt / Ford 3G alternator option as well. Right now not torquing on the redblock though:
 
Back
Top