• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

Pdx dl

Cleaned the T5 and M46 bellhousing. Throw-out bearing sleeve installed, new input and output seals installed, flywheel resurfaced, pressure plate on the way. STS driveshaft carrier bearing arrived. Custom crossmember on hand. Going to start with a cable set up. Will need to shorten front driveshaft and order a rear mount.

What am I forgetting?

Birthday next month / any shifter recommendations?



24F62891-1228-4298-A403-77565FEE2615-M.jpg
 
So far I am liking the Summit shifter (Steeda knockoff) better than the Hurst, despite not being as nicely made.
 
Culberro set me up with a sweet deal on a 3.73 ring and pinion.


4043B18E-CA6F-473A-9091-4B3FF4D419D7-M.jpg



To go with with the sweet deal that Harlard gave me on a clutch-type diff.


14BD186A-D65B-4C80-91EE-1E77A3ADB7F8-M.jpg



Should be a good match for the T5 ratios and allow me to go anywhere with the snow tires.
 
Lol you make it sound like I actually charged you money for that diff. I'm just glad you took it without question!
 
Back
Top