ZVOLV
<Master Tech>
- Joined
- Nov 19, 2002
- Location
- California
Good find. Pics?
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
Ok? Never had this issue on mine and it sits due to this "every other **** goes before my projectcar crap" sometimes more than 3 months or so.. ok.. i have INA VW Lifters? Dont know.. also there this urban legend that firing up the 6cyl whiteblock and shutting it off after a few seconds will deprime the lifters so it wont start and flood itself.. i never had this issue also..
It?s running.
https://youtu.be/odtPzRrLb-E here’s a link of it running, apologies for the huge delay but been ultra busy.
If timing is 90degrees off, can't you just rotate the plug wires by one position? Setup the engine at TDC #1 both valves closed, then see which post/tower the distributor rotor points to. Wire that post to #1 plug, rotate engine slightly to make sure you know the distributor rotation, then wire remaining posts for 1-3-4-2 firing order.