• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

T5 swap - TO bearing recommendations w kaplhenke brass?

Jack

junkman
Joined
Jul 7, 2011
Location
The Ass Cheek Of History
I think I finally have everything for the swap with the exception of the TO bearing

Using Kaplhenkie brass adapters for the mustang TO bearing....

However I don't know which TO bearing to get..

Please send link for reasonably priced one that isn't a piece of crap


Thanks
Jack
 
I always recommend the Mcleod adjustable throw out bearing. I find the standard length mustang ones are too short.
 
I think I finally have everything for the swap with the exception of the TO bearing

Using Kaplhenkie brass adapters for the mustang TO bearing....

However I don't know which TO bearing to get..

Please send link for reasonably priced one that isn't a piece of crap


Thanks
Jack

Link? Cannot find on his site. Great timing for me as well since I am ready to bolt my transmission to the redblock.
 
I always recommend the Mcleod adjustable throw out bearing. I find the standard length mustang ones are too short.


Might help others if you put that on your site. I tried searching threads before stating this thread but all could find is "mustang TO bearing"
 
Last edited:
I'm using the same National but mine was like $13 at Oreillys and then the dorman pilot bearing. But this is for a B20, so no adapter/bushings for the TO bearing. I get to take .1" off my fork.
 
Back
Top