• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

S60R brakes on a 240

Sorry, I know this thread is old but I didn't see a wheel thread for the STS machine adapters (front and rear). Is there any compiled info on wheels/offsets/spacers inside stock bodywork, 1"-2" lowered, etc with this kit?
 
Sorry, I know this thread is old but I didn't see a wheel thread for the STS machine adapters (front and rear). Is there any compiled info on wheels/offsets/spacers inside stock bodywork, 1"-2" lowered, etc with this kit?

No compiled info.
With trimmed fenders and stock body work you're not going to fit anything wider than 17x9 ET6 - 7 (245 tire).
Use the template here for checking your wheels if you have them already.
http://www.racetechnologies.com/sites/default/files/pdfs/1B1.7014A.pdf

RPF1s ET22 with a 16mm spacer are pretty tight (shown below with brembo GT template).
Fifteen52 tarmacs have loads of clearance.
Polaris wheels with a ~20mm spacer should fit.

Any flat faced non dished wheel should be easy to fit, luckily 240s run low offsets. Dished wheels get tricky.
 

Attachments

  • IMG_5237(1).JPG
    IMG_5237(1).JPG
    69.1 KB · Views: 105
Back
Top